The Market; all pre-war cars for sale

CdM  Original and conplete Citroen ignition-distributor coil for c4 original new in original wooden box

from a deceased estate , new un-machined aluminum P type block . I have roughly measured the barrels , it will easily take liners for 60mm bores and possibly as much as 62 depending in the required wall thickness of the liners . It weighs 17kgs so postage at cost but should not be ridiculous .

I am indebted to a very helpful and knowledgeable gent from Maine (USA) who has identified this as an Engine from a Locomobile Steam Car of 1899 or 1900. I previously thought it was a Stanley (which I guess is not too far out - see below). With an engine number of 444 the year of manufacture of 1899 would appear to be more likely than 1900 but y..

1920's German motorcycle handlebar mounted horn button; I don't know the maker.It is missing one of the nuts for the strap (easy to make) and is otherwise complete and ready to use. Made of brass and steel.I can post this, and I accept PayPal.

1930's era Bosch 6V FD6D S22 horn, with its original mounting bracket.It works well, but is missing the bakelite contact block.I can post this, and I accept PayPal.

2 x old St. Christophe for motorcycle or bike In very good shapeSize 4 x 4 cmSize 2,5 x 2,5 cm

Henri Barberet  1925 (damaged in corner)Moto 1914-1927

Vintage Francis Petrol/Fuel flip top Cap with F logo and threaded fixing sleeveDiameter of hole: ID 56mmClip fixing spring requires some attentionChrome has been painted in redMade in England£35 plus postagePostage:UK £4.95Europe £13.95USA, Japan £19.95Australia, Asi..

A pillion seat for a vintage motorcycle. Possibly French and clamps to the rear carrier of a vintage motorcycle. 

A nice brass head lamp from the 1920's for a vintage motorcycle of suitable for a small cyclecar. Made by Howes & Burley Ltd. The ML. 6" inches across the front of the lamp. Good silvered reflector, side mounts and a push/ pull on - off switch. Slight dent in the lens rim.