Frazer-Nash

GB, 1924 – 1960

(1) Frazer Nash Ltd, Kingston on Thames, Surrey, 1924 – 1925

(2) William G. Thomas & Frazer Nash Ltd, Kingston on Thames, Surrey, 1925 – 1926

(3) A.F.N. Ltd, Isleworth, Middlesex, 1926 – 1960

After Captain A. Frazer Nash left GN Ltd, the company he had helped to found, he at first made orthodox family Frazer Nash cars with shaft drive and water-cooled 4-cylinder engines of Deemster extraction. However, only a handful of light cars were made before Frazer Nash reverted to type. His new Frazer Nash car of 1924 was based largely on the GN, retaining its dog-clutch gear-change, separate chains for each of the three forward speeds, solid rear axle, hard quarter-elliptic suspension and high ratio steering. After the Plus-Power engine, Frazer Nash adopted the sv water-cooled 4-cylinder 1½-litre Anzani unit, giving 40bhp. Thus the GN’s combination of simplicity, strength, modest price, low weight and high powere were combined in a still brisker sporting machine. The Frazer Nash, together with the Aston-Martin, was Britain’s nearest answer to importe sports cars in the Bugatti Brescia class. It was so popular that the Frazer Nash remained in production, basically unchanged for 15 years, even though clutches and chain drive had been outmoded when the Frazer Nash was first introduced.

The principal alternations were to the power unit. A Meadows engine of the same size, but with overhead valves, and giving 50bhp, supplemented and then replaced the Anzani from 1929 and four forward speeds were provided on the Frazer Nash. Alternatively available from 1934 was the 1½-litre single ohc Frazer Nash engine, known as the Gough after its designer. This unit normally delivered 60bhp, but was also available supercharged in the Frazer Nash Shelsley or Frazer Nash TT replica chassis which had cantilever front springs. The Frazer Nash model names applied to the chassis, which could be fitted with any engine. Thus some Frazer Nash Shelsleys were equipped with the twin ohc 1.675cc 6-cylinder Blackburne, which was a smoother, more flexible unit.

It was clear that such a fundamentally primitive design could not last for ever, however efficient. H.J. Aldington, who had gained control of AFN Ltd in 1929, sought an alternative by importing the German BMW from 1934 – the BMW Type 319 engine was used in the chain-driven Frazer Nash chassis. The last Frazer Nash of the old pattern was made in 1939, but the Frazer Nash name re-appeared 8 years later attached to a thoroughly up-to-date car. Its power unit was developed jointly by AFN and Bristol, using the pre-war BMW Type 328 engine modified for higher output. In the Frazer Nash the 2-litre cross-push-rod operated ohv unit developed from 75 to 135bhp, depending on the stage of tune required. It was installed in a tubular chassis with transverse leaf independent front suspension and torsion bar rear suspension. There was a normal synchromesh gearbox and live axle. The Frazer Nash car was light – the chassis weighed 1.176lb – and held the road extremely well. The Frazer Nash High Speed Model of 1948 was developed into the Frazer Nash Le Mans Replica which gained a 3rd place in that race in 1949, as well as being the only British car to win the Targa Florio, in 1951. From 1953 a De Dion-type rear axle was used in some Frazer Nash cars, including the Frazer Nash Competition Model. When BMW began making a 2.6-litre V8 engine, this was put in the Frazer Nash Competition Model and in a new two-seater coupé, the Frazer Nash Continental. This was very expensive at £3.751. Only the BMW unit was available from 1957, increased to 3.2-litres in 1959. This was the last year at which Frazer Nash cars were seen at the Earls Court Motor Show and production of Frazer Nash ceased soon after that.

Source: Georgano, encyclopedia of motorcar; TRN

The information is written with the greatest of care. However, if you have any suggested amendments please contact us at office@prewarcar.com

Stoewer

D, 1899 – 1939

(1) Gebrüder Stoewer, Fabrik für Motorfahrzeuge, Stettin, 1899 – 1916

(2) Stoewer-Werke AG vorm. Gebr. Stoewer, Stettin, 1916 – 1939

The Stoewer car factory developed out of the Stoewer ironworks and was among the pioneers of the German car industry. After manufacturing motor cycles, tricycles and quadricycles for two years, Stoewer turned to cars in 1899. The first Stoewer car had a rear-mounted 2-cylinder engine. 4-cylinder Stoewer cars followed in 1901, and electric Stoewer cars were also produced. Best known were the 2-cylinder Type T Stoewer car (2.280cc and 3/12PS), the 4-cylinder Stoewer P4 (3.052cc and 11/22PS), the Stoewer G4 (1.500cc and 6/12PS) and the 6-cylinder Stoewer P6 (8.820cc and 34/60PS), evolved in the 1905-1907 period all Stoewer cars with shaft-drive. The Stoewer B1 of 6/16PS and the Stoewer B6 of 9/22PS which appeared in 1910 were also built by Mathis under licence. The G4 Stoewer car was the basis for the Stoewer B5, which Stoewer car in 1912 became famous by setting up a record at Brooklands with 67.7mph. The new range of Stoewer cars which appeared in 1913 was also based on successful earlier cars. They were the Stoewer C1 (6/18PS), Stoewer C2 (10/28PS) and C3 Stoewer car (6-cylinder and 19/45PS). Shortly before the outbreak of World War 1 the Stoewer car range was headed by the F4 Stoewer car with a 4-cylinder, 8.8-litre 33/100PS ohc engine. After the war an enormous Stoewer car appeared, the Stoewer D7, using a 6-cylinder 11.2-litre 42/120PS aero engine, as well as some conservative sv 4- and 6-cylinder Stoewer cars with rear wheel and transmission brakes. Front wheel brakes appeared on Stoewer cars in 1925. Stoewer introduced 8-cylinder Stoewer cars in 1928. These were the Stoewer Superior, Stoewer Marschall, Stoewer Gigant and Stoewer Repräsentant with engines ranging from 2-litres and 45bhp to 4.9-litres and 100bhp. The Stoewer car firm re-entered the economy class in 1931 with the V5, a front-driven Stoewer car with a V4 1.188cc engine, followed by the front-drive models R140 (1.369cc), R150 (1.488cc) and R180 (1.769cc). Another 8-cylinder was the front wheel drive Greif V8 with a 2.488cc engine, which was replaced by the conventional 6-cylinder 3.609cc Arcona Stoewer car in 1938. In 1934 the 1½-litre 4-cylinder Stoewer car and 2½-litre V8 Stoewer car were shown at the Brussels Salon by Monsieur Dewaet under the name D.S. (Dewaet-Stoewer). The Greif Junior was built under Tatra licence with an opposed 4-cylinder 1.474cc engine. It succeeded the Röhr Junior. In the middle of the range was the Stoewer Sedina with a 4-cylinder engine of 2.4-litres.

Production of private Stoewer cars was given up at the outbreak of World War 2 in 1939. The Stoewer car factory was destroyed during the war and production of Stoewer cars was not resumed.

Source: Georgano, encyclopedia of motorcar; HON   

The information is written with the greatest of care. However, if you have any suggested amendments please contact us at office@prewarcar.com