Isotta-Fraschini

Italy, 1900 – 1949

(1) Società Milanese d’Automobili Isotta, Fraschini & Cia, Milan, 1900 – 1904

(2) Fabbrica Automobili Isotta-Fraschini, Milan, 1904 – 1949

Cesare Isotta and Vincenzo Fraschini went into partnership in 1899, importing French cars (Mors, Renault) and proprietary engines (Aster); when their company was floated a year later the first Isotta Fraschini cars to bear their names were thinly disguised Renaults with shaft drive and 5hp single-cylinder Aster power units. A 12hp twin Isotta Fraschini car appeared in 1902, but the first wholly Italian designed Isotta Fraschini cars were not seen until 1903. These new Isotta Fraschini cars followed the fashionable Mercédès idiom with pair-cast 4-cylinder engines, side valves in a T-head, low tension magneto ignition, 4-speed gearboxes and side-chain drive. Initially three Isotta Fraschini carmodels were listed – a 4.180cc Isotta Fraschini 12, a 5.426cc Isotta Fraschini 16 and a 7.433cc Isotta Fraschini 24 – and there were few major changes until 1908, though foot accelerators and high tension ignition came in 1906 on Isotta Fraschini cars, and compressed-air starters were offered briefly in 1907, when the largest Isotta Fraschini carcar in the catalogue was the 11.3-litre Isotta Fraschini Tipo C.

Like FIAT and Itala, theIsotta Fraschini carfirm was quick to recognize the prestige value of racing: in 1905 they built an unsuccessful 17.2-litre machine with gear-driven ohc; in 1907 Minoia won the Coppa Florio with a Isotta Fraschini car; and in 1908 Trucco won the Targa Florio. The last year brought numerous successes in the USA, where 40 Isotta Fraschini cars were sold. By 1906 Isotta Fraschini were Italy’s second-ranking manufacturers, after FIAT, but they were hard hit by the Agadir Crisis, and in 1907 there was a successful takeover bid by Lorraine-Dietrich of France, whose intention it was to integrate the Milan Isotta Fraschini car-factory into their organization. By 1909, however, Isotta Fraschini were independent again and had sold a manufacturing licence to Praga in Prague.

A novelty in 1908 was a 1.327cc racing voiturette with ohc 4-cylinder monobloc engine said to run up to 3.500rpm; this Isotta Fraschini car went into limited production as the FENC type. More important, a successful uncoupled 4-wheel braking system was evolved by Oreste Fraschini and Giustino Cattaneo (who had joined theIsotta Fraschini car firm in 1905 and was to be responsible for all Isotta Fraschini cars up to 1935). This was available on production Isotta Fraschini cars by 1911, and three years later was standardized on the larger Isotta Fraschini cars. The 1909 range included a modern sv monobloc four, the ENC, available in 2.1-litre and 2.2-litre forms, though the old combination of T-head engine and chain drive persisted until 1913. The smaller Isotta Fraschini cars of 1914 closely paralleled the offerings of FIAT and Itala, coming in 2.3-litre, 3-litre and 4.4-litre sizes, with monobloc engines, 4-speed gearboxes, and optional electrics. However, for the enthusiast the Isotta Fraschini car company offered some 16-valve ohc sports cars with 4-wheel brakes and chain drive – the 6.2-litre Isotta Fraschini TM and the 10.6-litre Isotta Fraschini KM. The latter boasted dual magneto ignition, could be had with pear-shaped or V-radiator, and this Isotta Fraschini car was capable of 85-90mph on 140bhp. A Isotta Fraschini car with 130bhp 7.2-litre engine was raced unsuccessfully at Indianapolis in 1913, and there was also a shaft-driven variant of the TM, designated the Isotta Fraschini TC.

After World War 1 Cattaneo switched to a one-model Isotta Fraschini car programme with the Isotta Fraschini Tipo 8, a 5.880cc 9-bearing pushrod ohv straight-8 with alloy block, magneto ignition, 3-speed unit gearbox, central ball change, multi-plate clutch, semi-elliptic springing, and coupled 4-wheel brakes. Output was 80bhp at a low 2.200rpm, and the Isotta Fraschini car was conceived from the start as a chauffeur-driven carriage – hence the ponderous handling that attracted unfavourable comparisons with the contemporary 32CV Hispano-Suiza. Most straight-8s were exported: of 1.370 delivered Isotta Fraschini cars between 1919 and 1935 about 450 went to the United States and there were agencies in eight foreign capitals. In 1925 the Isotta Fraschini Tipo 8 gave way to the 7.4-litre Isotta Fraschini 8A with servo brakes, higher gear ratios, and an output of 110 – 120bhp; the 135 bhp Isotta Fraschini 8ASS sports version was said to do 104mph. By 1929 a Isotta Fraschini carlimousine cost £2.900 in London or $22.750 in New York. Two years later came the last of Isotta Fraschini car with a straight-8, the Isotta Fraschini 8B. This had a redesigned engine capable of 3.000rpm, coil ignition, and a stiffer and deeper frame; from 1932 Isotta Fraschini car was available with a 4-speed preselective gearbox, a conversion initiated by Antione Lago, then the Isotta Fraschini company London agent. In 1934 a 4-speed synchromesh box was offered, but by now sales were down to a trickle (only 25-30 8Bs were made all told, as against 950 8As) and the Isotta Fraschini car company, after unsuccessful negotiations for a merger with Henry Ford, elected to concentrate on aero engines. In 1936 Isotta Fraschini joined the Caproni organization, and their only roadgoing products were diesel trucks made under MAN-licence.

There was a final comeback of Isotta Fraschini cars in 1947 with the Rapi-designed 8C Monterosa – Isotta Fraschini never marketed a six. This Isotta Fraschini car had a 90 degrees ohc V8 engine mounted at the rear of a platform chassis, with independent front suspension by rubber in compression and swing-axle rear suspension. The 5-speed all-synchromesh gearbox incorporated an overdrive top, brakes were hydraulic, and a curious feature was an ignition warning light that went out in the event of trouble. Various cylinder capacities were tried: the 1947 Paris Salon Isotta Fraschini car had a 3.4-litre unit, but production models were to have had 2.544cc engines. Prototype Isotta Fraschini cars wore aerodynamic convertible and closed coachwork by Touring of Milan, but less than 20 Isotta Fraschini 8Cs had been built when the factory was shut down by order of the Italian government. The name Isotta Fraschini was acquired by the Breda armaments firm, who attempted a revival of the diesel commercial vehicle range as late as 1958

Source: Georgano, encyclopedia of motorcar; MCS

The information is written with the greatest of care. However, if you have any suggested amendments please contact us at office@prewarcar.com

Crossley

GB, 1904 – 1937

(1) Crossley Brothers Ltd, Gorton, Manchester, 1904 – 1910

(2) Crossley Motors Ltd, Gorton, Manchester, 1910 – 1937

The name of Crossley was famous on engines before it was famous on cars; in fact the Crossley company was the first in Britain to make 4-stroke internal combustion engines on the Otto principle. Later, Daimler engines were made under licence. The first Crossley car for sale, a chain-driven 22hp 4-cylinder, appeared for the 1904 season. A Crossley 28hp and Crossley 40hp followed, all three cars being of normal design and foreign inspiration. Their designer was J.S. Critchley, formerly of Daimler. Shaft drive appeared in 1906, and late in 1909, some were fitted with Allen-Liveredge front-wheel brakes, but Crossley cars, though excellent machines, made little impression until after 1910. The 4-litre 20hp Crossley which then made its bow was a well-constructed, durable and very popular car. Designed by A.W. Reeves, it lived on in modified form until 1925. Crossley’s finest hour came in World War 1, when, as the Crossley 20/25hp it achieved fame as a staff car in the Royal Flying Corps, and as an ambulance and light truck. The Crossley model was extremely popular with the British Royal Family after the war in its 25/30hp version. In its early years, however, it was rivalled by the 15hp. The efficiency of the latter’s  otherwise conventional engine, a side-valve four like the rest, gave this Crossley a better performance than most cars in its class and encouraged the makers to offer a special sporting variant, the Crossley Shelsley.

The Crossley Fifteen was discontinued after 1914, but a new Crossley arrived for 1921. This Crossley 19.6hp was a rather more modern design, having a detachable cylinder head, and it was cheaper and lighter on fuel than its 25/30hp companion. The performance was about the same. It was also made in sporting form as the Crossley 20/70hp, but this model was heavy, like the ’Crossley 19.6’ itself, and the brakes were not good enough for the 75mph that was available. Crossley did not make a serious attempt to invade the middle-class market until 1923, when the Crossley 12/14hp, later called the Crossley Fourteen, was introduced. Like its brothers, this was a simple side-valve four, in this case of 2.4 litres, but was more modern, with its unit construction of engine and gearbox and central gear-change. The Crossley Fourteen was a very successful model, being flexile and, thanks to its light weight, both roomy and economical. It survived until 1927. By this time the two bigger Crossley cars were giving way to a much more up-to-date car; the Crossley company’s first six and its first overhead-valve machine. This Crossley 18/50hp model was a spacious, heavy 2.6-litre car with good brakes but somewhat lacking in power. Its engine was enlarged to 3.2-litres and 20.9hp for 1928. At the same time a new small Crossley of similar design, the 2-litre Crossley 15.7hp was introduced, to which a sporting alternative reviving the Shelsley name was  added in 1929. Lagonda’s 16/80 model used this engine later. The 6-cylinder Crossley 15.7hp continued until 1934 and the Crossley 20.9hp until 1937. Wilson pre-selector gearboxes were fitted from 1934.

In 1932, the Crossley company had introduced a light car, the Crossley Ten. This was an assembled vehicle powered by an 1100cc Coventry-Climax engine with overhead inlet valves. It was too heavy (a drawback compounded by the pre-selector gearbox), it was very low-geared and its brakes were mediocre. Another mistake was Crossley’s attempt to market the Burney rear-engined car with all-independent suspension. It was given a 15.7hp Crossley engine and a Wilson box, but it was too unconventional in appearance and handling. Very few were made. In 1935, Crossley introduced its new Regis range of small cars with handsome bodies styled by C.F. Beauvais. They consisted of the Crossley Ten and a new Crossley 1½-litre six of the same design also powered by Coventry-Climax, both with a new lowered frame. Both cars, together with the last Crossley 20.9s, disappeared after 1937.

Crossley assembled other people’s cars as well as making their own, beginning with the Willys-Overland Model 4 in 1920. The Gorton-produced Willys came to include more and more British-made parts, such as a Morris Oxford engine. A less likely diversion was an attempt of Crossley in 1921 to make the Type 22 Bugatti in England, but only a handful of these Crossley-Bugattis appeared. In 1922-1933 the Crossley factory made the AJS as well.

Source: Georgano, encyclopedia of motorcar; TRN

The information is written with the greatest of care. However, if you have any suggested amendments please contact us at office@prewarcar.com