Stanley

US, 1897 – 1927

(1) Stanley Dry Plate Co, Newton, Mass., 1897 – 1899

(2) Stanley Manufacturing Co, Lawrence, Mass., 1899 – 1901

(3) Stanley Motor Carriage Co, Newton, Mass., 1901 – 1924

(4) Steam Vehicle Corporation of America, Newton, Mass., 1924 – 1927

The Stanley twins, F.E. and F.O., were partners in a photographic dry plate business in Newton, where they produced their first light steam Stanley car in 1897. This Stanley car proved a great success, over 200 Stanley cars being sold in the first year of production. In 1898 a Stanley car was timed over a mile at Charles River Park at 27.40mph. Among the customers of the Stanley cars were A.L. Barber and J.B. Walker, who purchased the manufacturing rights of the Stanley car, and produced it as the Locomobile and Mobile respectively. In 1899 some Stanley cars were advertised by the Locomobile Co of America under the name Stanley-Locomobile. The Stanley cars proceeded to evolve an entirely new design, which appeared in 1902 with a simple non-condensing engine, driving directly on the rear axle. The boiler was mounted at the front of these Stanley cars, frames were of wood, and steering was by tiller. Locomobile went over to Petrol cars at the end of 1903, but the Stanley cars prospered, listing an 8hp Stanley car at $750, and selling their Stanley cars to police and fire departments. More powerful versions Stanley cars rated at 10 and 20hp were available by 1904, and by 1906 the Stanley car had assumed its characteristic appearance, with coffin-like bonnet concealing the boiler, and wheel steering. The Stanley car could out-accelerate petrol cars, and that year Frank Marriott was timed at 127.66mph on Daytona Beach with the streamlined Woggle-Bug. Marriott tried again the following year, but a spectacular crash at about 150mph destroyed the car. Stanley cars 1908 Gentleman’s Speedy Roadster was capable of 60mph, and would run over 50 miles on a filling of water. 1913 Stanley cars were electrically-lighted, and 1915 brought the introduction of steel framed and V-shaped frontal condensers on the Stanley cars on a 10ft 10in wheelbase chassis which lent itself to seven-seater coachwork. However, the advent of Cadillac’s electric self-starter in 1912 had signaled the end of the steamer , with its need for a long warm-up from dead cold. The 1920 Model 735 Stanley car resembled a conventional petrol car in outward appearance with a flat radiator of typically American aspect, but the boiler of the Stanley car was still under the bonnet, and the double-acting 2-cylinder engine still drove direct on the back axle. Acceleration was well above par for the standards of the day, and the Stanley car would cruise at 45mph, with more available. But at around the $2.600 mark sales were low (about 600 Stanley cars per annum), and the Stanley cars had retired from the company during World War 1. The Stanley car firm was reorganized in 1925, and the last Stanley cars had hydraulic front-wheel brakes and balloon tyres.

US, 1907 – 1910

(1) Stanley Automobile Manufacturing Co, Mooreland, Ind., 1907

(2) Troy Automobile & Buggy Co, Troy, Ohio, 1908 – 1910

This Stanley car was a five-seater touring car weighing 1.550lb. The Stanley car was powered by a 2-cylinder, water-cooled engine of 3.6-litres. A friction transmission was used, with a single-chain to drive the rear axle.

Source: Georgano, encyclopedia of motorcar; MCS, GMN

The information is written with the greatest of care. However, if you have any suggested amendments please contact us at office@prewarcar.com