Unknown wheels for a beaded edge tyre, probably French, has 52 spines in the centre(If I counted right).Sizes can be seen on the photos.Seem to be in good condiiton.
A set of the four special, Plated, Raised Countersunk 1/4" x 3/8"" BSF sets that held the prop. shaft cover in place on 'Ulsters' and, possibly, other Austin 7 cars. These are very old stock, but in reasonable condition. I once had a large stock and found these few in the proverbial tobacco tin ! I have a couple of sets only. As far as I know th..
A set of the four special, Plated, Raised Countersunk 1/4" x 1/2" BSF sets that held the instrument panel in place on 'Ulsters' and, possibly, other Austin 7 cars.These are very old stock, but in reasonable condition. I once had a large stock and found these few in the proverbial tobacco tin ! I have a couple of sets only. As far..
Pair of heavy sidemounts for spare wheels of circa 1933 Packard , in good condition. Could also be used on other big cars of the period 1930 till 1950.€ 400.
A N.O.S. head and exhaust manifold gasket set for an Austin 7. The head gasket is of the High Compression type.There is very slight damage, just beyond the final stud hole, to one end of the exhaust gasket. This is visible in the photo. This is very old stock, so please be aware it may possible be a Copper/Asbestos composite. However, i cannot b..
Austin 7, engine front timing gear which fits on the nose of the crankshaft. These are original Austin parts. They have no '+' or '-' markings so must be considered to be for a within tolerances assembly. However, in my experience, timing gear pairs are best matched by fitting as a pair, regardless of marks and measuring the backlash unti..